AFTER SALES SUPPORT
23
1300 855 831
support@scheppach.com.au
MODEL: HCE2400 PRODUCT CODE: 62005 09/2018
AUS
HCE2400 Maintenance and cleaning/Troubleshooting/Storage and transport
X. Maintenance and cleaning
Pull out the power plug before every maintenance operation. This also includes
connecting to the water supply or trying to eliminate leaks. There is a risk of electro-
cution or of injury from moving parts.
Cleaning
It is recommended to clean the high pressure washer after each use.
Never direct the water jet against the high pressure washer, nor clean the
high pressure washer under owing water. This could give rise to the danger
of electric shock and damage the high pressure washer!
Always keep the high pressure washer clean. Do not use any detergents or solvents.
• Always keep the ventilation slots clean and free from dirt and dust.
• Only clean the high pressure washer with a soft brush or a slightly moist cloth.
• If the variable nozzle (15) is soiled or blocked, you can remove any foreign bodies
in the nozzle using the nozzle cleaning needle (11).
Maintenance
The high pressure washer is maintenance free.
XI. Troubleshooting
Problem Possible Cause Action
The high pres-
sure washer
does not work.
No electrical voltage at the high
pressure washer.
Check the fuse, power cable
and power plug and have
them replaced by qualied
personnel if necessary.
The cross section of the extension
cable is not large enough and/or
the extension cable is too long.
Use extension cables with
larger cross sections and/or
use shorter extension cables.
The mains voltage is lower than
that specied.
Contact the power supply
company if necessary.
The high pressure washer is
frozen.
Check and thaw if necessary.
To Next Page
Loading...
General