AFTER SALES SUPPORT
e-mail: info.aldi@positecgroup.com
1300 889 028 (toll free)
MODEL No.: CS20V • 63350 • 01/2019
AFTER SALES SUPPORT
1300 889 028 (toll free)
e-mail: info.aldi@positecgroup.com
MODEL No.: CS207 • 63350 • 01/2019
Battery Maintenance
To maintain battery capacity, always refer to the specic instructions in the
supplied manual included with the purchase of ALDI 20V Xnity Batteries.
It is recommended to recharge your battery every two months. Store only
fully charged batteries. They should therefore be recharged from time to
time. The place of storage must be dry.
CAUTION. Electrical and battery operated units that no longer work
should not be disposed of in the household waste! They are to be collected
separately, in accordance with your local waste disposal regulations.
ATTENTION! Batteries must be removed from battery powered tools
and disposed of separately in accordance with relevant waste battery
regulations.
Batteries must never be disposed of with domestic waste!
Discard power tools that are no longer usable at a local collection point.
Collection and disposal of packaging materials separately by types
complying with local rules and regulations. For details, please contact your
local council.
Storage & Transporting
• When transporting the circular saw, always remove the CBUUFSZQBDL
fromthe saw.
• When not using the circular saw, store both the battery and the circular
saw in a clean, dry environment.
1. Maintenance
WARNING:
the battery (27) is removed before making any adjustments.
Cleaning
1. Keep the tool’s air vents unclogged and clean at all times.
2. Remove dust and dirt regularly. Cleaning is best done with a rag.
3. Re-lubricate all moving parts at regular intervals.
4. If the body of the saw needs cleaning, wipe it with a soft damp cloth.
A mild detergent can be used but nothing like alcohol, petrol or other
cleaning agent.
5. Never use caustic agents to clean plastic parts.
CAUTION. Do not use cleaning agents to clean the plastic parts of the
tool. A mild detergent on a damp cloth is recommended. Water must
never come into contact with the tool.
General inspection
over time.
To Next Page
Loading...
