22
22
AFTER SALES SUPPORT
1300 889 028 (toll free)
e-mail:
MODEL No.:
info.aldi@positecgroup.com
AG36 • 8290 • 06/2019
8.Operation
IMPORTANT: Before starting the angle grinder, ensure that the
workpiece is secure i.e clamp the work piece so it is securely held
down. A non secured work piece can cause injury to the user during
operation.
8.1 Switch on/off (see fig. E1, E2)
To start the grinder, first press back the rear of the on/off switch (3),
then push the on/off switch (3) forward.
To lock the on/off switch (3), press the on/off switch down at the
front until it engages.
To switch off the grinder, briefly press down the back of the on/off
switch (3) and then release it.
8.2 To use the grinder (see fig. F)
Attention: Do not switch the grinder on while the disc is
in contact with the workpiece. Allow the disc to reach
full speed before starting grinding.
1) Hold your angle grinder with one hand on the main handle (4)
and other hand firmly around the auxiliary handle (7).
2) Ensuring that your work piece is secure, place the grinding disc
(9) with a light, even pressure on the work surface for maximum
grinding efficiency. It should never be necessary to operate
E1 E2
To Next Page
Loading...
General