Battery Cover
4 AA Batteries
(NOT INCLUDED)
5
First remove the battery cover by pulling down on both
tabs at the top of the cover. Next install 4 AA batteries
with the correct polarity. Finally replace the battery cover
and make sure the two tabs are secure.
Make sure the drone power switch is in the
OFF position. Push the battery compartment
door away from the center of the drone and
swing it open.
Slide the battery pack into the battery
compartment.
Plug the battery pack into the drone then
close and snap the battery compartment
back into place. Switch on the drone’s power
switch when ready to fly.
CAUTION:
1. Make sure the batteries are
installed with the correct polarity.
2. Do not mix old and new batteries.
3. Do not mix different types
of batteries.
INSTALLING THE TRANSMITTER BATTERY
INSTALLING THE DRONE BATTERY
To Next Page
Loading...