BWS platform scales Technical Manual
• Connect the adaptor pin in to the indicator adaptor jack.
Adaptor jack is locating, back side of the indicator.
• Adaptor connects into your AC power socket.
Pluggable equipment must be installed near an easily accessible socket
outlet with a protective ground/ earth contact.
• Turn on the On/Off key. If you want to turn off, press the key again.
• Display will be show the scale capacity and will be starting self checking.
• After self checking, display will be come to normal weighing mode.
• Warm-up time of 15 minutes stabilizes the measured values after
switching on.
• Calibrate with exact calibration weights, minimum 1/3 of the scale capacity
want to use for calibration. For calibration see details in parameter.
Then you can start your operation
To Next Page
Loading...
