22
EN
SYMPTOM CAUSE SOLUTION
Landroid Vision fails to
connect to the internet.
Please check your router has the
correct settings.
Make sure your router is 2.4GHz or 5GHz. If your router has two
settings, please enable the 2.4GHz or 5GHz band.
Make sure your router is set to 802.11 mode and wireless setting
is b/g/n mixed.
Make sure your router has the SSID Broadcast function enabled
when you connect the machine with the app.
You can close it after you connect successfully.
Make sure DHCP function is enabled.
If you changed your Wi-Fi network, you need to connect Landroid
Vision to the new network.
If you have a “Fritz! box” router, please make sure activate
“Allow communication between devices in same network” in the
settings.
Please check whether the router
is disconnected or WIFI SSID is
changed.
Make sure the router is connected and WIFI SSID is correct.
Your Landroid Vision
beeps when you are
adjusting “month / hour /
minute”
It is normal.
Anticlockwise the to adjust.
Environmental protection
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with
your Local Authority or retailer for recycling advice.
Remove the used battery pack from the appliance and dispose of it at the most convenient recycling facility. If in doubt, consult
your local environmental protection department.
To Next Page
Loading...
