21
EN
SYMPTOM CAUSE SOLUTION
Landroid Vision cannot
correctly dock with the
charging pile.
Environmental influences. Restart Landroid Vision.
Poor connection caused by
debris on the charging strip.
Clean the contact pins located on the charging pile and the char-
ging strip on Landroid Vision using a cloth.
The QR code is sheltered.
Make sure the QR code is clear and that there is nothing directly
on it or above it.
The green light on the
charging pile turns
on before charging is
complete.
The charging base is overheating
or overcooling.
Place the charging base in a shady area or wait until it reaches
the normal temperature.
Landroid Vision wheels
skid or repeatedly slip.
Obstacles, such as twigs and
branches may be lodged under
Landroid Vision.
Remove objects from underside of Landroid Vision.
The lawn is too wet.
Exclude the wet or soft ground areas by using the magnetic strip
or by creating a non-grass pathway that is more than 50mm
wide until the lawn is dry again.
Landroid Vision slips out
of its working area.
Low grip of Landroid Vision drive
wheels.
Please check the wheels are clean and free of mud in order to
have the maximum grip possible.
The slope is steeper than 30%
(17
o
).
Exclude the sloped area by using the magnetic strip or by crea-
ting a non-grass pathway that is more than 50mm wide directly
beside the slope.
Recognition error.
Remove the obstacle is there is one. Using the magnetic strip or
by creating a non-grass pathway that is more than 50mm wide
on the lawn edge ensure that the mower functions correctly.
Landroid Vision operative
system crashes when
charging or on standby.
Software or display fault. Restart Landroid Vision.
Landroid Vision shuts
off when docking in the
charging pile.
Landroid Vision fails to charge
due to over temperature pro-
tection and is powered off.
Place the charging base in a shady area or wait until the tempe-
rature has cooled down.
Poor connection.
Check the LED light on the charging pile. Check the connection
between the contact pins located on the charging pile and the
charging strip.
Landroid Vision stops in
the working area.
There is an obstacle in the wor-
king area.
Remove the obstacle from Landroid Vision’s working area.
The cutting height is set too low
for the length of the grass or the
grass is too dense.
Raise the cutting height and then gradually lower.
Landroid Vision flips over.
There is an inclined obstacle on
the lawn.
Exclude the obstacle from Landroid Vision’s working area.
To Next Page
Loading...
