19
Owner’s Manual EN
edges and minimize the frequency of replacing the blades. Each
cutting blade will last up to 2 months when it is programmed to
mow every day. Always check to see if the blades are chipped or
damaged and replace them if they are. When the cutting blades are
dull and worn out, they should be replaced with the spare blades
provided with your Landroid
®
. Spare blades are also available at
your nearest WORX retailer.
A. Replace the Blades
After some time, usually every season, your Landroid
®
’s blades
will need to be replaced. When replacing the blades, make sure to
replace all of them at the same time. You can replace them with
one of the spare blade kits and extra blade screws supplied with
your Landroid
®
.
Before attempting to replace your Landroid
®
’s blades, turn the
power off and put on protective gloves and follow these steps:
1. Open the battery cover and remove the battery.
2. Take the screws off the blades with a screwdriver. (See Fig. M)
3. Firmly screw on the new blades.
4. Refit the battery and the battery cover.
IMPORTANT: After screwing the blade to the blade
disc, make sure the blade is able to spin freely.
9.2 Keep it clean
WARNING: Before cleaning, turn your Landroid
®
OFF. Put on protective gloves before cleaning the
blade turning disc and do not rinse or flush with water.
A. Cleaning the Body
Your Landroid
®
will live a much happier and longer life if it is
cleaned regularly. Since your Landroid
®
is an electric machine, you will need to take care when cleaning. DO NOT use
a hose, high pressure washers and do not pour running water on your Landroid
®
. It is best to use a spray
bottle filled with water. When cleaning the machine body, use a soft brush or clean cloth and avoid using solvents or
polishes (See Fig. N). Lastly, remove all build up of grass clippings and debris.
B. Cleaning the Underside
Again, it is important that you power the Landroid
®
OFF and wear protective gloves before touching the blade
turning disc.
First, flip your Landroid
®
upside down to expose its underside. Here you will see the blade disc, the chassis, and the front
wheel and driving wheels. Clean everything thoroughly with a soft brush or moist rag.
WARNING: NEVER clean the underside of Landroid
®
with running water. Component damage can
occur. (See Fig. O1, O2)
Rotate the blade disc to ensure it rotates freely. Check the blades spin freely around the fixing screws. Remove any
obstructions.
IMPORTANT: Remove any lodged debris so that it does not cause a crack in the blade disc. Even the
tiniest crack can decrease your Landroid
®
's mowing output.
M
N
To Next Page
Loading...
