24
Owner’s Manual EN
Landroid
®
cannot correctly dock
with the charging base.
Environmental influences.
Reposition the charging base. Avoid of a
wall, metal or other objects.
Poor connection caused by debris on
the charging strip.
Clean the contact pins located on the
charging base and the charging strip on
Landroid
®
using a cloth.
The boundary wire on both sides of
the charging base is not long enough.
Make sure the boundary wire on both sides
of the charging base is straight for at least
0.8m.
The green light on the charging
base turns on before charging is
complete.
The charging base is overheating,
the LED will display “Battery charge
overtemp! Please wait cooling down”.
The temperature of the charging base
is below 0
0
C.
Place the charging base in a shady area or
wait until the temperature has cooled down
or warmed up.
Landroid
®
runs outside the
boundary wire. Landroid
®
does
not mow an area within a
boundary wire zone. Landroid
®
reverses or rotates erratically
near the boundary wire.
The lawn is wet, uneven or there are
obstacles.
Wait until the lawn is dry. Make the lawn
even and remove obstacles.
The boundary wire of another
Landroid
®
or another branded robotic
mower is positioned too closely.
Ensure your Landroid
®
boundary wire
has at least 1m of spacing between the
neighboring boundary wire.
The boundary wire has been installed
with tight corners.
Check the boundary wire to ensure the
corners are smooth.
In wet conditions, the boundary wire
electric signal may leak were wire has
been joined or repaired.
Check boundary wire joints. Insulate to
provide a fully waterproof connection.
The cutting area is larger than the
allowable cutting area for Landroid
®
.
Contact service agent.
Landroid
®
wheels skid or
damage lawn.
Foreign obstacles, such as twigs
and branches may be lodged under
Landroid
®
.
Remove foreign objects from underside of
Landroid
®
.
The lawn is too wet. Wait until lawn has dried.
The boundary wire has been installed
with tight corners.
Check the boundary wire to ensure the
corners are smooth.
Landroid
®
exits the boundary
wire due to high speed when
going down a hill.
The boundary wire is placed on a
slope steeper than 17% (10°).
Reposition the boundary wire away from
slopes that are steeper than 17% (10°).
Please refer Installation Guide for details.
Landroid
®
crashes when
charging or on standby.
Software or display fault. Restart Landroid
®
.
Landroid
®
shuts off when
docking in the charging base.
Landroid
®
fails to charge due to
over temperature protection and is
powered off.
Place the charging base in a right place or
wait until the temperature has cooled down.
Poor connection.
Check the LED light on the charging base.
Check there are no breaks in the boundary
wire.
Check the connection between the contact
pins located on the charging base and the
charging strip.
To Next Page
Loading...
