What to do if Worx Trimmer fails to operate?
If your Worx Trimmer fails to operate, the battery may be discharged, so recharge it. Another reason might be that the battery is either too hot or too cold; allow it to reach room temperature. A broken motor or damaged internal wiring could also be the cause; replace the motor or inspect and repair the wiring.
Why Worx Trimmer machine does not cut?
If your Worx Trimmer machine isn't cutting, it might be due to a broken line, so replace the cutting line. Also, the battery may not be fully charged, so recharge it. If the motor is broken or its speed is too low, replace the motor. Finally, check for grass entangled around the cutting head and clear it.
What to do if command feed does not work on Worx Trimmer?
If the command feed on your Worx Trimmer isn't working, it could be because the cutting line is not wound well, so rewind the line. Also, the line might be tangled, so untangle it. Alternatively, the line may be used up, so replace the cutting line.
Why Worx Powershare WG170 cutting time per battery charge is too short?
If the cutting time per battery charge is too short, it could be because the battery hasn't been used for a long period or has only been charged for a short time, so use the battery regularly and ensure adequate charging. Also, check if the grass is too high and trim it to a manageable height. Another reason could be a defective battery, in which case you should replace it.
Why is my Worx Trimmer running intermittently?
If your Worx Trimmer runs intermittently, the motor might be broken, so replace it. It could also be due to a battery that's not fully charged, so recharge the battery. Another possible cause is a defective On/Off switch, which should be replaced.
What to do if Worx Powershare WG170 has excessive vibrations or noise?
Excessive vibrations or noise in your Worx Trimmer may be due to a defective machine, so inspect and repair it. Another cause could be that the line spool is not wound well, in which case you should rewind the line.
What to do if Worx Trimmer battery charge indicator does not light up?
If the battery charge indicator on your Worx Trimmer does not light up, ensure the charger is properly plugged in. Another reason could be a defective socket outlet, mains cable, or battery charger, so inspect and replace any defective components.
What to do if Worx Powershare WG170 Trimmer battery charge indicator is continuously lighting with no charging possible?
If the battery charge indicator is continuously lit and no charging is possible on your Worx Trimmer, reinsert the battery to ensure it is properly connected. Also, clean the battery contacts, as they may be contaminated. If the problem persists, the battery may be defective and need replacement.
General safety precautions for all appliances, covering environment, attire, and tool usage.
Specific safety instructions for battery-powered gardening tools, including charging and battery handling.
Detailed guide on automatic, command, and manual line feeding, plus winding instructions.
General| Power Source | Battery |
|---|---|
| Battery Voltage | 20V |
| Battery Type | Lithium-Ion |
| Warranty | 3 years |
| Cutting Width | 12 in |
| Line Diameter | 0.065 in |
| Features | Telescopic Shaft |
To Next Page
