Worx WA0863 - Getting Started; Installation

7
Getting started
EN
INSTALLATION
Before proceeding with the installation please make sure your Landroid’s firmware is updated to the last version. For more information on
firmware upgrade please refer to the “Maintenance” section of the Landroid-o-pedia (https://support.worx-europe.com).
Follow the steps below according to the Landroid model you own
1. Turn off Landroid
OK
START
SET
1
2. Remove Landroid blades using a screwdriver – wear gloves to
avoid injury
3
3. Take out the slot cover using a screwdriver
4. Plug the cables of the Off Limits until you hear a “click” and
insert the module in its slot
CLICK!
4
5
5. Put the cover back and secure it with
the included screws.
6
6. Screw Landroid blades back in and
turn Landroid on.
Landroid S 300 (WR130E)
Landroid M 500 (WR141E)