How to fix a dry chain on a Worx Pole Saw?
A dry chain on your Worx Pole Saw may be caused by: * No oil in the reservoir. * A clogged vent in the oil filler cap. * A clogged oil passage. Check these to ensure proper lubrication.
Why does my Worx WG323 rip, vibrate, and not saw properly?
If your Worx Pole Saw rips, vibrates, or doesn't saw properly, the chain tension may be too loose, the chain might be dull or worn out, or the chain teeth could be facing the wrong direction. Check these aspects to resolve the issue.
What to do if the chain/chain bar over-heats on my Worx WG323?
If the chain or chain bar of your Worx Pole Saw overheats, it could be due to several reasons: * There's no oil in the reservoir. * The vent in the oil filler cap is clogged. * The oil passage is clogged. * The chain is over-tensioned. * The chain is dull. Check these to address the overheating issue.
Why does my Worx WG323 Pole Saw fail to operate?
If your Worx Pole Saw fails to operate, it might be due to an out of battery or a faulty fuse. Check the battery and fuse to resolve this issue.
Why does my Worx WG323 Pole Saw operate intermittently?
If your Worx Pole Saw operates intermittently, it could be due to overheating, applying too much pressure while cutting, a loose connection, defective internal wiring, or a defective on/off switch. Check these components to troubleshoot the problem.
Ensures a safe work environment, free from hazards.
Guidelines for safe use of electricity to prevent shock.
Techniques and precautions to minimize the risk of dangerous kickback.
Instructions for switching the tool on/off and performing cuts.
Procedures for cleaning, maintaining, and storing the chainsaw.
General| Type | Pole Saw |
|---|---|
| Power Source | Battery |
| Battery Voltage | 20V |
| Battery Type | Lithium-Ion |
| Voltage | 20V |
| Amperage | 2.0 Ah |
| Maximum Cutting Length | 10 feet |
| Chain Pitch | 3/8 inch |
| Chain Gauge | 0.050 in |
| Bar Length | 8 in |
| Max Cutting Diameter | 6 in |
To Next Page
