To Next PageTo Next PageHow to fix a dry chain on Worx WG349E Pole Saw?
If your Worx Pole Saw chain is dry, it could be due to a few reasons. First, check if there is oil in the reservoir and refill it if needed. Also, the vent in the oil filler cap might be clogged, or the oil passage could be clogged. Clean the cap and the oil passage outlet to resolve these issues.
Why is my Worx WG349E Pole Saw chain/chain bar overheating?
Your Worx Pole Saw chain or chain bar may be overheating due to several reasons: there may be no oil in the reservoir, the vent in the oil filler cap could be clogged, the oil passage might be clogged, the chain could be over tensioned, or the chain might be dull. Refill the oil, clean the cap, clean the oil passage outlet, adjust the chain tension, or sharpen/replace the chain, depending on the cause.
What to do if my Worx WG349E Pole Saw rips, vibrates, and doesn't saw properly?
If your Worx Pole Saw is ripping, vibrating, or not sawing properly, it could be due to a few reasons related to the chain. The chain tension might be too loose, the chain could be dull or worn out, or the chain teeth might be facing the wrong direction. Try adjusting the chain tension and sharpening or replacing the chain.
Safe work area practices and electrical precautions for power tools.
User alertness, PPE, and proper power tool operation guidelines.
Safe charging, handling, and care of battery packs.
Emphasizes professional servicing with identical replacement parts.
Rules for handling, storing, and disposing of battery packs safely.
Explains symbols for injury reduction, warnings, and electrical hazards.
Covers symbols for protective equipment and environmental precautions.
Details symbols for batteries, disposal, and locking mechanisms.
Lists technical specifications and available accessories for the pole saw.
Presents noise emission levels and vibration values according to standards.
Step-by-step instructions for fitting the chain and guide bar.
Details on how to properly tension the saw chain.
Instructions for attaching and removing the extension pole.
Guides for adjusting the saw head angle and rear handle position.
Procedures for filling the oil tank for automatic chain lubrication.
Initial checks, battery charging, and installation.
Tool operation, cutting techniques, and kickback prevention.
Safe methods for cutting with shoulder strap and extension pole.
Detailed guide on safely pruning tree branches.
Instructions for cleaning, lubrication, and tightening parts.
Guidance on bar maintenance, chain replacement, and sharpening.
A table listing common issues and their recommended solutions.
Statement of conformity to relevant directives and standards.
General
