Worx WG324 Series - Page 22

22
Scie d’élagage sans fil F
Symptom
Possible
Cause
Remedy
Chainsaw
fails to
operate
Out of battery.
Charge the
battery pack.
Fuse faulty. Replace fuse.
Chainsaw
operates
intermittently
Over heating
Place the
machine in a
cool, ventilated
place to cool it
down
Applying too
much pressure
while cutting.
Applying
relatively less
pressure while
cutting
Loose
connection.
Contact service
agent 1-866-
354-Worx
(9679).
Internal wiring
defective.
On/off switch
defective.
Chain/chain
bar over-heats
Chain is over
tensioned
Adjust chain
tension
Dull chain
Sharpen chain
or replace
Chainsaw rips,
vibrates,
does not saw
properly
Chain tension
too loose
Adjust chain
tension
Dull chain
Sharpen chain
or replace
Chain worn out Replace chain
Chain teeth are
facing in the
wrong
direction
Reassemble
with chain in
correct
direction