Worx WG384 - Page 6

Cordless Chain Saw EN
6
3
2
2
W
Y
Z
X
2˝
2˝
1
1
1
2
2/3
1
1/3
1
2
2/3
1/3
Fig.1
Fig.2
Fig.3
Fig.4
Fig.5
Fig.6
When bucking on a slope always stand on the uphill
side of the log, as illustrated in Figure 6. When
“cutting through”, to maintain complete control
release the cutting pressure near the end of the
cut without relaxing your grip on the chain saw
handles. Don’t let the chain contact the ground. After
completing the cut, wait for the saw chain to stop
before you move the chain saw. Always stop the
motor before moving from tree to tree.
3
2
2
W
Y
Z
X
2˝
2˝
1
1
1
2
2/3
1
1/3
1
2
2/3
1/3
Fig.1
Fig.2
Fig.3
Fig.4
Fig.5
Fig.6
SYMBOLS
To reduce the risk of injury, user
must read instruction manual
WARNING
Wear ear protection
Wear eye protection
Wear dust mask
Do not expose to rain
Wear head protection
Wear protective gloves
Protective footwear
Do not burn
Do not expose to rain or water
Li-Ion battery, battery must be
recycled
Contact of the guide bar tip with any
object should be avoided
Tip contact can cause the guide bar to
move suddenly upward and backward,
which can cause serious injury
Always use two hands when
operating the chain saw
POSITEC Inc. has established
a partnership with the RBRC
Corporation to recycle any Positec
batteries with the RBRC-call2recycle
seal. For environmental protection,
please do not discard batteries in the
trash. After the batteries’ life cycle is
ended, then please call 1-800-822-8837
for a free service that will properly
dispose of the battery.