Worx WG743E Manual

13
Cordless Lawn mower EN
20V Battery
WA3553 4.0 Ah
WA3014 4.0 Ah
20V Charger
WA3760 0.4 A
WA3860 2.0 A
WA3880 2.0 A
WA3772 2.0 A
WA3883 4.0 A
We recommend that you purchase your accessories
from the same store that sold you the tool. Choose
the type according to the work you intend to
undertake. Refer to the accessory packaging for
further details. Store personnel can assist you and
offer advice.
NOISE DATA
A weighted sound pressure L
wA
= 75dB(A)
K
pA
3 dB (A)
A weighted sound power L
wA
= 89.3 dB(A)
K
wA
3 dB (A)
Wear ear protection
VIBRATION INFORMATION
Typical weighted vibration a
h
< 2.5 m/s²
Uncertainty K = 1.5 m/s²
WARNING: The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which the
tool is used dependant on the following examples and
other variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained.
Using the correct accessory for the tool and ensuring it
is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration syndrome if
its use is not adequately managed
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may signicantly reduce the exposure level
over the total working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
OPERATION INSTRUCTION
NOTE: : To reduce the risk of injury, user must
read instruction manual
Intended Use
This product is intended for domestic lawn mowing.
ASSEMBLY AND
OPERATION
ACTION FIGURE
ASSEMBLY
Assembling the handle bar
NOTE: Choose one of the two holes
in the lower handle for desired
handle’s height.
See Fig. A1,
A2, A3, A4, A5
Assembling grass collection bag
See Fig. B1,
B2, B3, B4
Fitting grass collection bag to the
lawn mower
NOTE: Depress the grass collection
bag slightly to ensure that it is
completely installed.
NOTE: Take the mulching insert out
of the lawn mower before tting the
grass collection bag.
See Fig. C1,
C2, C3
Checking the battery charge condition
NOTE: Fig. D1 only applies for the
battery pack with battery indicator
light.
See Fig. D1
Charging the battery pack
NOTE: The batteries are shipped
uncharged. Each battery must be fully
charged before the rst mow.
Always fully charge the two batteries at
same time. More details can be found
in charger’s manual.
See Fig. D2

Worx WG743E Specifications

General

Type	-
Cutting width	400 mm
Product color	Black, Orange
Number of wheels	4 wheel(s)
Maximum lawn area	500 m²
Maximum cutting height	88 mm
Minimum cutting height	38 mm
Number of height positions	7
Cutting clearance adjustment	Yes
Power source	Battery
Battery voltage	20 V