SYMBOLS
Only use the battery charger
indoors
Read instruction handbook before
operation this machine
Keep bystanders away.
Beware of sharp blades. Blades
continue to rotate after the motor
is switched off - Remove disabling
device before maintenance
Fuse
T 2 A time lag fuse with rated current of 2 A
The output plug is with positive
center pole and negative outer pole
Do not dispose of batteries. Return
exhausted batteries to your local
collection or recycling point.
Do not burn
Do not expose to rain or water
This product has been marked with a
symbol relating to removing electric
and electronic waste. This means that
this product shall not be discarded with
household waste but that it shall be returned
to a collection system which conforms to the
European Directive 2002/96/CE. It will then
be recycled or dismantled in order to reduce
the impact on the environment. Electric and
electronic equipment can be hazardous for
the environment and for human health since
they contain hazardous substances.
INTENDED USE
This product is intended for domestic
lawn mowing.
CHARGER SAFETY RULES
1. Plug charger directly into an electrical
outlet. DO NOT ABUSE THE CORD. Never
carry charger by cord. Do not disconnect
the charger from the outlet or mower by
pulling it by the cord.
2. CAUTION: To reduce the risk of fire,
electrical shock, or personal injury do
not attempt to use this charger with any
other product.
Likewise, do not attempt to charge the
battery with any other charger.
3. Do not service mower with charger or
safety key installed.
4. Do not operate a damaged charger. Replace
damaged cords or charger immediately at
an authorized WORX service center.
5. Always charge the mower in a dry area
protected from the weather. Do not expose
the mower or charger to rain. Do not
charge in wet locations. Do not charge
mower when temperature is above 104°F
(40°C) or below 41°F (5°C).
6. Keep the mower and charger away from
water, heat sources, (Such as radiators,
heaters, stoves...etc.) flames, or chemicals.
Be careful not to damage the charger cord,
by keeping cord away from sharp edges.
CHARGING PROCEDURE
1. Charging can be carried out only with the
battery REMOVED from the machine (See
A).
2. Insert the plug of the charger into the wall
receptacle, the Charging indicator light will
be green.
3. Plug the charger connector into the
receptacle on the battery, the light will
switch to be red indicating that you have
power and the battery is being charged.
4. The light will turn to be green when
charging is completed;
To Next Page
Loading...
