12
not apply excessive pressure. Bits can bend causing 
breakage or loss of control, resulting in personal 
injury.
SAFETY WARNINGS FOR BATTERY CELLS INSIDE THE TOOL
a)  Do not dismantle, open or shred cells. 
b)    Do not short-circuit charging terminal. Do not store 
power tool haphazardly in a box or drawer where 
charging terminal may short-circuit each other or be 
short-circuited by conductive materials. 
When power 
tool is not in use, keep it away from other metal objects, like 
paper clips, coins, keys, nails, screws or other small metal 
objects, that can make a connection from one charging 
terminal to another.
c)  Do not expose power tool to heat or fire. Avoid 
storage in direct sunlight.
d)  Do not subject power tool to mechanical shock.
e)  In the event of battery leaking, do not allow the liquid 
to come into contact with the skin or eyes. If contact 
has been made, wash the affected area with copious 
amounts of water and seek medical advice.
f)  Keep power tool clean and dry.
g)  Wipe the charging terminals with a clean dry cloth if 
they become dirty.
h)  Power tool needs to be charged before use. Always 
refer to this instruction and use the correct charging 
procedure.
i)  Do not maintain power tool on charge when not in 
use.
j)  After extended periods of storage, it may be 
necessary to charge and discharge the power tool 
several times to obtain maximum performance.
k)    Recharge only with the charger specified by Worx 
other than that specifically provided for use with the 
equipment. 
l)  Keep power tool out of the reach of children.
m)  Retain the original product literature for future 
reference.
n)  Dispose of properly.
o)  Do not mix cells of different manufacture, capacity, 
size or type within a device.
p)  Do not use any cell which is not designed for use with 
the equipment.
q)  Keep the battery away from microwaves and high 
pressure.
GENERAL SAFETY WARNINGS 
FOR YOUR BATTERY CHARGER
WARNING: Read all safety 
warnings and all 
instructions. 
Failure to follow 
the warnings and instructions 
may result in electric shock, fire 
and/or serious injury.