20
TROUBLE SHOOTING
Problem Possible cause Solution
Battery will
not charge
1. Charger not
plugged into a
working outlet.
2. Surrounding air
temperature is too
hot or too cold.
1. Plug charger into
a working outlet.
Check current by
plugging in a lamp.
2. Move charger
to an appropriate
place which tem-
perature is suitable
for the charger.
Switch cannot
be pressed
Forward/Reverse
switch at middle
position
Make sure switch
is on Forward or
Reverse rotation
according to proj-
ect need.
Driver stops
during driving
screws
Driver battery is out
of power
Make sure the driv-
er is fully charged
before using it.
Bit Cartridge
will not rotate
when Cover
slides.
The cover is not
fully open
Make sure the
Cover is fully open
and past the red
line on the tool.
ENVIRONMENTAL PROTECTION
Waste electrical products must not be disposed of with
household waste. Please recycle where facilities exist.
Check with your local authorities or retailer for recycling
advice.
DECLARATION OF CONFORMITY
We,
Positec Germany GmbH
Grüner Weg 10, 50825 Cologne, Germany
Declare that the product,
Description Battery-powered Screwdriver
Type WX255 WX255.1 WX255.2 (250~269 - designation
of machinery, representative of Battery-powered
Screwdriver)
Function Tightening and loosening screws, nuts
Complies with the following directives,
2006/42/EC
2011/65/EU&(EU)2015/863
2014/30/EU
2014/35/EU
Standards conform to:
EN 62841-1,
EN 62841-2-2,
EN 55014-1,
EN 55014-2,
EN 60335-1,
EN 60335-2-29,
To Next Page
Loading...
