16
TROUBLE SHOOTING
Problem Possible cause Solution
Battery will not charge 1. Charger not plugged into a
working outlet.
2. Surrounding air temperature is
too hot or too cold.
1. Plug charger into a working outlet.
Check current by plugging in a lamp.
2. Move charger to an appropriate
place which temperature is suitable
for the charger.
Switch cannot be pressed Forward/Reverse switch at middle
position
Make sure switch is on Forward or
Reverse rotation according to project
need.
Driver stops during driving screws Driver battery is out of power Make sure the driver is fully charged
before using it.
Bit Cartridge will not rotate when
Cover slides.
The cover is not fully open Make sure the Cover is fully open
and past the red line on the tool.
ENVIRONMENTAL PROTECTION
Waste electrical products must not be disposed of with household waste. Please recycle where facilities exist.
Check with your local authorities or retailer for recycling advice.
To Next Page
Loading...
