10
Lithium-ion Brushless Impact Driver EN
Typical weighted
vibration
Vibration emission value
a
h
=9.37m/s²
Uncertainty K = 1.5m/s²
The declared vibration total value may be used for
comparing one tool with another, and may also be
used in a preliminary assessment of exposure.
WARNING: The vibration emission value
during actual use of the power tool can differ
from the declared value depending on the ways in
which the tool is used dependant on the following
examples and other variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained
The use the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimize your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
vibration accessories.
Avoid using tools in temperatures of 10
0
C or less.
Plan your work schedule to spread any high vibration
tool use across a number of days.
ACCESSORIES
WX292 WX292.1 WX292.9
Battery Pack 2 1 /
Charger 1 1 /
Belt Hook 1 1 1
Bit Clip 1 1 1
We recommend that you purchase your accessories
from the same store that sold you the tool.Refer to
the accessory packaging for further details. Store
personnel can assist you and offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The power tool is intended for driving in and
loosening screws.
ASSEMBLY AND OPERATION
ACTION FIGURE
BEFORE OPERATION
Checking the battery pack condition See Fig A1
Removing the battery pack See Fig.A2
Charging the battery Pack See Fig.A3
Installing the battery pack See Fig.A4
ASSEMBLY AND ADJUSTMENT
Assembling the Hook and Bit Holder
Warning: To reduce the risk
of serious personal injury,
do not suspend the tool overhead
or suspend objects from the belt
hook. Only hang tool’s belt hook
from a work belt.
See Fig. B1,
B2,B3,B4
Inserting and Removing Bits and
Socket
See Fig. C1,
C2
Forward/Reverse/Lock
Warning: Never change the
direction of rotation when
the chuck is rotating, wait until it is
stopped!
See Fig.
D1,D2,D3
OPERATION
Operating the On/Off Switch
Warning: Do not operate for
long periods at low speed
because excess heat will be
produced internally.
See Fig. E
To Next Page
Loading...
