171616
Compact Circular Saw EN
TROUBLE SHOOTING
Symptom Possible Causes Possible Solution
Tool will not start when operating the on/
off switch.
Power cord not plugged in.
Power cord is broken.
Carbon brush has worn down
Check to make sure power cord is connected
well into a working outlet.
Unplug the power cord. Replace it using a
qualified maintenance person.
Replace the carbon brush using a qualified
maintenance person.
Cutting depth is less than that is set.
Sawdust accumulated at the rear of
the base.
Shake out sawdust. Consider connecting a
vacuum for dust collection.
Blade spins or slips
Blade is not tightly engaged with the
spindle.
Remove the blade, and reassemble it as
described in Mounting and Removing the
Blade section.
Blade will not cut a straight line.
Blade is dull.
Blade is not mounted properly.
Saw is not being guided properly.
Mount a new, sharp blade on the saw.
Check that blade is properly mounted.
Use a parallel guide.
Blade kicks back when beginning a cut Blade is not spinning fast enough
Allow the saw blade to reach full speed prior
to beginning a cut in the material.
DECLARATION OF
CONFORMITY
We,
Positec Germany GmbH
Grüner Weg 10, 50825 Cologne, Germany
Declare that the product,
Description Worx Electric Circular Saw
Type WX437 WX437.X (4-designation of machinery,
representative of Saw)
Function Cutting various materials with a rotating
toothed blade
Complies with the following Directives,
2006/42/EC
2014/30/EU
2011/65/EU&(EU)2015/863
Standards conform to:
EN 62841-1
EN 62841-2-5
EN 55014-1
EN 55014-2
EN IEC 61000-3-2
EN 61000-3-3
EN 60745-1
EN 60745-2-22
The person authorized to compile the technical file,
Name Marcel Filz
Address Positec Germany GmbH
Grüner Weg 10, 50825 Cologne, Germany
2020/10/23
Allen Ding
Deputy Chief Engineer, Testing & Certification
Positec Technology (China) Co., Ltd
18, Dongwang Road, Suzhou Industrial
Park, Jiangsu 215123, P. R. China
To Next Page
Loading...
