To Next PageTo Next PageWhy does my Worx Saw blade kick back when starting a cut?
If the Worx Saw blade kicks back when starting a cut, it's likely that the blade isn't spinning fast enough. To resolve this, allow the saw blade to reach its full speed before you begin cutting into the material.
What to do if the cutting depth on my Worx XL WX427 Saw is less than set?
If the cutting depth of your Worx Saw is less than what you've set, it might be due to sawdust accumulation at the rear of the base. Try shaking out the sawdust. You might also want to consider connecting a vacuum for dust collection to prevent this issue.
General| Type | Compact Circular Saw |
|---|---|
| Blade Diameter | 4-1/2 in |
| Dust Extraction | Yes |
| Laser Guide | Yes |
| Max Cutting Depth | 46mm |
| No-Load Speed | 3700 RPM |
| Cutting Depth at 90° | 46mm |
Detailed list of all components of the circular saw with their corresponding numbers.
Information on measured sound pressure, sound power, and K-factors for noise.
Tips and warnings to reduce the risk of hand-arm vibration syndrome.
Explanation of kickback causes and methods to avoid it.
Instructions for safe operation and maintenance of the lower guard.
Extra safety guidelines for circular saws and cutting-off machines.
Read all safety warnings; avoid direct eye exposure to the beam.
Symbols related to safety, protection, and basic warnings.
Symbols indicating proper disposal and maintenance procedures.
Guide to assembling and operating the saw with figure references.
Instructions for maintaining the tool and its parts for optimal performance.
Solutions for the tool not starting or the blade spinning/slipping.
Troubleshooting for incorrect cutting depth, straightness, or kickback.
Instructions for replacing the mains plug, especially for UK and Ireland.
Statement confirming the product's compliance with relevant EU directives and standards.
