Worx WX523 WorxSaw - User Manual

Questions and Answers:

B
Bobby MillerJul 27, 2025
Why does my Worx WX523 WorxSaw blade spin or slip?
- K
  Kevin RamirezJul 27, 2025
  Several factors could be at play if your Worx Saw blade spins or slips: * The blade may not be tightly engaged with the spindle. In this case, remove the blade and reassemble it according to the SAW BLADE ASSEMBLY AND REMOVING instructions. * A dull blade can cause slipping. Try mounting a new, sharp blade on the saw. * Improper mounting can also lead to this issue. Ensure the blade is correctly mounted. * Finally, improper guidance during use can cause the blade to slip. Use a parallel guide to maintain control.
M
mrodriguezAug 3, 2025
What to do if the Worx Saw cutting depth is less than set?
- M
  mariagarciaAug 3, 2025
  If the cutting depth of your Worx Saw is less than what you've set, it might be due to sawdust accumulation at the rear of the base. Shake out the sawdust to resolve this. You might also consider connecting a vacuum for dust collection to prevent future build-up.
W
William KerrAug 11, 2025
What to do if my Worx Saw blade kicks back when beginning a cut?
- R
  Robert HarrisonAug 11, 2025
  If the blade kicks back when starting a cut with your Worx Saw, the blade might not be spinning fast enough. Allow the saw blade to reach full speed before beginning to cut the material.
J
Jessica JohnsonAug 18, 2025
How to fix a Worx WX523 WorxSaw that will not start when the battery park is powered off?
- L
  Lisa HallAug 18, 2025
  If your Worx Saw doesn't start, consider these potential causes: 1. The battery park might not be properly plugged in. Check to ensure it's securely connected to a working outlet. 2. The battery park may be powered off. Try charging the battery. 3. The carbon brush might be worn down. If this is the case, have a qualified maintenance person replace the carbon brush.