What to do if my Worx Cordless Saw won't start?
If your Worx Cordless Saw doesn't start when you use the on/off switch, there are a few potential reasons. First, ensure the battery pack is properly connected to a working outlet. Second, check if the battery pack is powered off and needs charging. Finally, a worn carbon brush can also cause this issue, in which case you should have it replaced by a qualified maintenance person.
Why won't my Worx Cordless Saw cut a straight line?
If your Worx Cordless Saw blade won't cut a straight line, it could be due to several reasons. A dull blade is a common cause, so try mounting a new, sharp blade. Also, ensure the blade is properly mounted. Lastly, improper guidance can lead to crooked cuts, so use a parallel guide to help.
What to do if the blade on my Worx Cordless Saw kicks back?
If the blade of your Worx Cordless Saw kicks back when starting a cut, it's likely because the blade isn't spinning fast enough. Make sure to allow the saw blade to reach its full speed before you begin cutting into the material.
Why is the cutting depth less than set on my Worx Cordless Saw?
If the cutting depth of your Worx Cordless Saw is less than what you've set, it might be due to sawdust accumulation at the rear of the base. Try shaking out the sawdust to resolve this. Also, consider connecting a vacuum for dust collection.
How to fix a spinning or slipping blade on a Worx Cordless Saw?
If the blade of your Worx Cordless Saw spins or slips, it's likely that the blade is not tightly engaged with the spindle. Remove the blade and reassemble it as described in the SAW BLADE ASSEMBLY AND REMOVING section.
Keep hands away from cutting area and blade. Do not reach underneath the workpiece. Adjust cutting depth.
Understand kickback reaction to pinched, jammed, or misaligned saw blade. Take precautions.
Check lower guard for proper closing before each use. Do not clamp or tie lower guard open. Check spring operation.
Do not dismantle, open, or shred cells. Do not short-circuit. Keep away from metal objects. Avoid heat or fire.
To Next Page
General
