10
20V Cordless 18 gauge Nail/Staple Gun
EN
3. TECHNICAL DATA
Type WX840 WX840.X (840 - designation of
machinery, representative of nail gun)
WX840 WX840.X **
Voltage
20 V Max. ***
Magazine capacity 100 nails
Nailer speed 80 nails/min
Nail type 18 gauge
Nail length
Brad nail 20mm - 50mm
Crown
staple
19mm - 40mm
Machine weight
3.2kg 2.9kg
Work with nails of other brands:
Brad nails: RAPID
®
– Type 8; NOVUS
®
– E Type J;
PREBENA
®
– Type J
Crown staples: RAPID
®
– Type 90
** X=1-999θA-ZθM1-M9 there are only used for
different customers, there are no safe relevant
changes between these models.
***Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal voltage
is 18 volts.
Category
Type Capacity
20V Battery
WA3550 1.5Ah
WA3550.1 1.5Ah
WA3551 2.0Ah
WA3551.1 2.0Ah
WA3553 4.0Ah
20V Charger
WA3880 2.0A
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to
the accessory packaging for further details. Store
personnel can assist you and offer advice.
NOISE INFORMATION
A weighted sound pressure L
pA
= 77.5dB(A)
A weighted sound power L
wA
= 88.5dB(A)
K
pA
&K
wA
3dB(A)
Wear ear protection.
VIBRATION INFORMATION
Vibration total values (triax vector sum) determined
according to EN 60745:
Vibration emission
value:
a
h
= 3.633m/s
2
Uncertainty K = 1.5m/s
The declared vibration total value may be used for
comparing one tool with another, and may also be used
in a preliminary assessment of exposure.
WARNING The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which the tool
is used dependant on the following examples and other
variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained
The use the correct accessory for the tool and ensuring it
is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration accessories are used.
And the tool is being used as intended by its design and
these instructions.
This tool may cause hand-arm vibration syndrome
if its use is not adequately managed.
WARNING To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off and
when it is running idle but not actually doing the job. This
may significantly reduce the exposure level over the total
working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration tool
use across a number of days.
To Next Page
Loading...
Need help?
General
