Worx WX840 Series - Environmental Protection; Troubleshooting; Declaration of Conformity

12
20V Cordless 18 gauge Nail/Staple Gun
EN
7. ENVIRONMENTAL PROTECTION
Waste electrical products must not be disposed of with household waste. Please recycle where facilities
exist. Check with your local authorities or retailer for recycling advice.
8. TROUBLESHOOTING
Symptom Possible Causes Possible Solution
Tool does not operate properly:
green light flashing
green light on
red light flashing
red light on
Tool is overheat
No nails
Jammed nails
Low battery
Wait until the tool cools down
Replenish nails
Removing a jammed nail
Recharge battery
Tool operates properly, but
fasteners do not drive fully
Depth of drive isn’t deep enough
Nail is too long for wood
hardness
Adjust depth of drive
Use nail length that is appropriate for
wood
Tool operates properly, but
fasteners are driven too deep
Depth of drive is too deep Adjust depth of drive
Tool jams frequently Incorrect nails
Damaged nails
Loose magazine
Dirty magazine
Verify that nails are the correct size
Replace nails
Tighten screws
Clean magazine
9. DECLARATION OF
CONFORMITY
We,
Positec Germany GmbH
Grüner Weg 10, 50825 Cologne, Germany
Declare that the product
Description Worx Cordless Nail Gun
Type WX840 WX840.X (840 - designation of
machinery, representative of nail gun)
Function Fastening various materials
Complies with the following Directives:
2006/42/EC
2014/30/EU
2011/65/EU&(EU)2015/863
Standards conform to
EN 60745-1
EN 60745-2-16
EN 55014-1
EN 55014-2
The person authorized to compile the technical file,
Name Marcel Filz
Address Positec Germany GmbH
Grüner Weg 10, 50825 Cologne, Germany
2020/02/17
Allen Ding
Deputy Chief Engineer, Testing & Certification
Positec Technology (China) Co., Ltd
18, Dongwang Road, Suzhou Industrial
Park, Jiangsu 215123, P. R. China