E-2
EQUIPMENT/
SELF-INSTALLATION
Programming TV/VCR Combo
1 Turn on your TV/VCR combo and insert a video cassette.
2 On the remote control, press VCR once. Press and hold SETUP until the VCR key
blinks twice, then release SETUP.
3 Use the Setup Codes For TV/VCR combos visit our URL at www.wowway.com/
referenceguide to locate the brand name and then enter the first four-digit code for
your TV/VCR combo. If you perform this procedure correctly, the VCR key will blink
twice.
NOTE: If the VCR key did not blink twice after entering the code’s last digit, then repeat steps
2 through 3 and try entering the same code again.
If you’ve located a TV/VCR setup code that works your TV/VCR combo and a separate TV
code is also listed, you’ll need to program this code into the remote control to access volume
control.
4 Aim the remote control at your TV/VCR combo and press POWER once. The device
should turn off. If it does not respond, repeat steps 2-3, trying each code listed for
your brand until you find one that works.
5 For future reference, write down each working device code in the boxes below:
Searching for Your Code
If your home entertainment device does not respond to the Atlas Universal
Remote Control after trying all of the codes listed for your brand or if your
brand is not listed at all, try searching for your code. For example, to search
for a code for your TV:
1 Turn on your TV.
2 On the remote control, press TV once; it will blink once. Then press and hold SETUP
until the TV key blinks twice, then release SETUP.
3 Enter 9 - 9 - 1. The TV key will blink twice.
4 Aim the remote control at the TV and slowly alternate between pressing PWR and TV.
Stop when the TV turns off.
NOTE: In the search mode, the remote control will send IR codes from its library to the
selected device, starting with the most popular code first.
5 Press SETUP once to lock in the code. The TV key will blink twice.
6 To search for the codes of your other devices, repeat steps 1 through 5, but substitute
the appropriate key (e.g., AUX, DVD, AUD, or CBL) for the device you are searching
for.
Checking the Codes
If you have set up the Atlas Universal Remote Control using the Searching
For Your Code procedure, you may need to find out which four-digit code is
operating your equipment.
For example, to find out which code is operating your TV:
1 On the remote control, press TV once; it will blink once. Then press and hold SETUP
until the TV key blinks twice, then release SETUP.
2 Enter 9 - 9 - 0. The TV key will blink twice.
3 To view the code for the first digit, press 1 once. Wait 3 seconds and count the
number of times the TV key blinks (e.g., 3 blinks = 3).
NOTE: If a code digit is “0”, the selected mode key will not blink.
4 Repeat step 3 three more times for the remaining digits. Use 2 for the second digit, 3
for the third digit, and 4 for the fourth digit.
5 To check for other device codes, repeat steps 1 through 4, but substitute the
appropriate key (e.g., AUX, DVD, AUD, or CBL) for the device you are checking.
To Next Page
Loading...
Need help?
General
