E-3
EQUIPMENT/
SELF-INSTALLATION
Programming Channel Control Lock
By default, the remote control’s channel-control capabilities are locked to the
cable converter. The aected keys* are 0-9, CH+, CH-, ENTER, and LAST. This
will guarantee that you do not inadvertently change a channel on your TV or
VCR. However, you can de-activate this feature to allow full access to these
keys in the TV and VCR modes.
*NOTE: This feature does not affect the AUD mode.
To De-Activate Channel Control Lock:
1 On the remote control, press CBL once; it will blink once. Then press and hold SETUP
until the CBL key blinks twice, then release SETUP.
2 Enter 9 -7- 3. The CBL key will blink twice.
3 Press CH- once. The CBL key will blink four times.
4 Now, the remote control will provide TV and VCR channel-control capabilities while in
the TV or VCR mode.
To Re-Activate Channel Control Lock:
1 On the remote control, press CBL once; it will blink once. Then press and hold SETUP
until the CBL key blinks twice, then release SETUP.
2 Enter 9 -7- 3. The CBL key will blink twice.
3 Press CH+ once. The CBL key will blink twice.
4 Now, regardless of what mode you select (except AUD), only the channel control
capability of your cable converter will be accessible.
Programming ID Lock
The Atlas Universal Remote Control is locked at the factory to operate a
Scientific Atlanta cable converter. However, if you have another brand or model
of cable converter or satellite service that you would like to control, then you’ll
need to perform the following steps to unlock the ID Lock, enter in a new
manufacturer’s code, and lock the ID Lock again.
1 Turn on the cable converter.
2 On the remote control, press CBL once; it will blink once. Then press and hold SETUP
until the CBL key blinks twice, then release SETUP.
3 Enter 9 - 8 - 2. The CBL key will blink four times, indicating ID Lock is unlocked.
4 Upon completion, perform the remaining steps (5 and 6 on this page) to again lock
the ID Lock.
5 On the remote control, press CBL once; it will blink once. Then press and hold SETUP
until the CBL key blinks twice, then release SETUP.
6 Enter 9 - 8 - 2. The CBL key will blink twice, indicating ID Lock is again locked.
To Next Page
Loading...
Need help?
General
