WPM WELHOME PRO KD-310 - Cleaning Guidelines

10
Cleaning Guideline
Below is the cleaning procedure of Coffee Machines of KD-310.
Please follow the Procedures to clean.
System
CO CLEAN
ST CLEAN
Reminder
Procedures Cleaning Reminder
1. Press the CLEANING button to stop
the current cleaning procedure. The
cleaning reminder will be shown after
the machine is switched on until the
current circuit is cleaned.
2. During the cleaning procedures, “NO
WATER” will be shown if there is no
water in the water tank, press the
SETTING/P button to continue cleaning
after refilling the tank.
3. Please make sure there is water in
the water tank during the cleaning
procedures.
Press the button TWICE, “ST
CLEAN” will appear on the LED screen.
Then, press the button to clean the
water circuit of the steam wand. ( The
machine will return to standby-mode
automatically if the button is not
pressed in 5 seconds.)
Three buttons ( ) will be lit one by
one repeatedly to signal the start of the
cleaning procedure.
Turn the steam wand on, this procedure
will last for around 10 minutes.
“CHECK” will be shown on the LED
screen to remind users to turn the
steam wand off.
Press the button ONCE, “CO CLEAN”
will appear on the LED screen. Then,
press the button to clean the water
circuit of the brewing head. (The
machine will return to standby-mode
automatically if the button is not
pressed in 5 seconds.)
Three buttons ( ) will be lit one by
one repeatedly to signal the start of the
cleaning procedure, this procedure will
last for around 7 minutes.
“CO CLEAN” will be
shown by the machine
when it reaches the
preset water consump-
tion level to remind the
user to clean the
brewing head.
“ST CLEAN” will be
shown by the machine
when the steam wand
reaches the level of
300-time-usage to
remind the user to clean
the steam wand. When
the steam wand reaches
a 400-time-usage level,
the machine cannot be
used until the steam
wand is cleaned.
When both the preset
water consumption level
and steam wand usage
level meet the cleaning
reminder requirements,
“ST CLEAN” and “CO
CLEAN” will be shown
alternately.