6
BX1800 · BX2200, WSM
SPECIFICATIONS
SPECIFICATIONS
NOTE: * Manufacture’s estimate
The company reserves the right to change the specifications without notice.
W1028103
Model BX1800 BX2200
PTO power 10.2 kW (13.7 HP)* 12.4 kW (16.7 HP)*
Engine
Maker KUBOTA
Model D722-E-BX D905-E-BX
Type Indirect Injection. Vertical, water-cooled, 4-cycle diesel
Number of cylinders 3
Bore and stroke 67 × 68 mm (2.64 × 2.68 in.) 72 × 73.6 mm (2.83 × 2.90 in.)
Total displacement 719 cm
3
(43.9 cu.in.) 898 cm
3
(54.8 cu.in.)
Engine gross power (DIN) 13.4 kW (18.0 HP) 16.4 kW (22.0 HP)
Rated revolution 53.3 r/s [3200 min
-1
(rpm)]
Maximum torque
41.5 N·m (4.23 kgf·m, 30.6 ft-lbs) / 36.7
to 43.3 r/s [2200 to 2600 min
-1
(rpm)]
54.9 N·m (5.6 kgf·m, 40.5 ft-lbs) / 36.7
to 43.3 r/s [2200 to 2600 min
-1
(rpm)]
Battery 12 V, CCA : 435 A, RC : 62 min. 12 V, CCA : 535 A, RC : 80 min.
Starting system Electric starting with cell starter, 12 V, 1.4 kW
Lubrication system Forced lubrication by trochoidal pump
Cooling system Pressurized radiator, forced circulation with water pump
Fuel Diesel fuel No. 2-D [above −10 °C (14 °F)], Diesel fuel No. 1 [below −10 °C (14 °F)]
Capacities
Fuel tank 21 L (5.5 U.S.gals, 4.6 Imp.gals.)
Engine crankcase (with filter) 1.9 L (2.01 U.S.qts., 1.67 Imp.qts.) 2.5 L (2.64 U.S.qts., 2.20 Imp.qts.)
Engine coolant (with recovery tank) 2.9 L (3.06 U.S.qts., 2.55 Imp.qts.) 3.5 L (3.70 U.S.qts., 3.08 Imp.qts.)
Transmission case 10.1 L (2.7 U.S.gals, 2.2 Imp.gals.)
Front axle case 4.7 L (4.97 U.S.qts., 4.14 Imp.qts.)
Dimensions
Overall length (without 3P) 2025 mm (79.7 in.)
Overall width 1145 mm (45.1 in.)
Overall height (with ROPS) 1800 mm (70.9 in.)
Overall height (top of steering wheel) 1200 mm (47.2 in.)
Wheel base 1400 mm (55.1 in.)
Minimum ground clearance (bottom of
hitch bracket)
170 mm (6.7 in.)
Tread
Front 910 mm (35.8 in.)
Rear 820 mm (32.2 in.)
Weight 570 kg (1257 lbs) 590 kg (1301 lbs)
Travelling
system
Tires
Front 18 × 8.50 – 8 (Turf)
Rear 26 × 12.00 – 12 (Turf)
Steering Hydrostatic power steering
Transmission Main-hydrostatic transmission, Range gear shift (2 forward and 2 reverse)
Brake Wet disc type
Min. turning radius (without brake) 2.3 m (7.5 feet)
Differential Bevel gear
Hydraulic
system
Hydraulic control system Directional control, auto-return lever system
Pump capacity 21.0 L/min. (5.5 U.S.gals./min., 4.6 Imp.gals./min.)
Three point hitch SAE Category I
Max. lift force (24 in. behind lift points) 3040 N (310 kg, 684 lbs)
PTO system
Clutch Wet type, multiple discs
Mid
PTO shaft
USA No. 5 (KUBOTA 10-tooth) involute spline
Revolution
41.7 r/s [2500 min
-1
(rpm)] / engine 52.1 r/s [3125 min
-1
(rpm)]
Rear
PTO shaft
SAE 1-3/8, 6 splines
Revolution
9.0 r/s [540 min
-1
(rpm)] / engine 51.1 r/s [3068 min
-1
(rpm)]
To Next Page
