Wulfsberg Electronics P-2000 and C-2000/RT-2000 Operator’s Manual
Document 150-041102 Revision A Page 6 of 37
Keypad Buttons
The P-2000 has a 12 button keypad. Each button’s functions are described below.
1:DIR Toggles the active transceiver in and out of
DIRECT mode. Use this button to enter a “1” during
keypad entry mode.
2:MODE This button will cycle through the
enhanced modes of operation. Use this button to
enter a “2” during keypad entry mode.
3:PROG This button will display the PROGRAM
PAGE. Use this button to enter “3” during keypad
entry mode.
4:DIM This button will display the page used to
control the display’s brightness. Use this button to
enter a “4” during keypad entry mode.
5:OTAR This button will initiate an “Over The Air
Rekey” for the transceiver under cursor control . Use
this button to enter a “5” during keypad entry mode.
#:CHAN This button will select channel entry mode
using the keypad. Use this button to enter a “#”
during keypad entry mode.
6:KEY This button will prompt the user for a
transmit encryption key to override the preset value
for the active transceiver. Use this button to enter a
“6” during keypad entry mode.
7:MSG This button will allow the user to view
system messages pages. Use this button to enter a “7”
during keypad entry mode
8:SCAN This button will send the active transceiver
into scan mode. Use this button to enter an “8”
during keypad entry mode.
9:PVTφ This button will toggle the active
transceiver in and out of private mode. Use this
button to enter a “9” during keypad entry mode.
0:QMEM This button allows the user to quickly
select a preset channel using the Quick Memory
channel entry mode. Use this button to enter a “0”
during keypad entry mode.
*:HOME This button will display the HOME PAGE,
except in some advanced modes of operation, where
it will return the user to a previous page or mode of
operation. Use this button to enter a “*” during
keypad entry mode.
To Next Page
Loading...
