Würth Acctiva Easy Basic 1206 - Operation Overview; General Remarks; Controls and Connections; Selector Switch Warning

1
Operation
Warning! An incorrectly set selector switch can lead to severe product damage
and poor results. Set selector switch according to the type of battery used and/
or battery voltage.
Hinged mains plug (0°, 45°, 90°)
LCD
Selector switch (depending on charger
type)
Socket for charger lead
Dear reader, Thank you for the trust you have placed in our company and congratulati-
ons on buying this high-quality product. These instructions will help you familiarise
yourself with the product.Reading the instructions carefully will enable you to learn about
the many different features it has to offer. This will allow you to make full use of its
advantages.
Please also note the safety rules to ensure greater safety when using the product.
General remarks
Controls and
connections
Setting the
selector switch
If your device is equipped with a selector switch, it will be able to perform a number of
different functions (see rating plate):
- Charging characteristic selector switch e.g. wet or gel battery
„Wet“ setting A:
For charging liquid (Pb, Ca, Ca silver) or fixed (AGM, GEL, MF, sealant) electrolyte
batteries that are used in starter or traction applications.
„Gel“ setting B:
For charging liquid (Pb, Ca, Ca silver) or fixed (AGM, GEL, MF, sealant) electrolyte
batteries that are used in standby applications (e.g. emergency power systems) or at
temperatures above 35°C.
Important! Do not charge dry batteries (primary cell) with this charger.
Note! Setting the selector switch incorrectly can result in the following:
- Charger displays incorrect test results
- Charger switches to „error“
- Battery will not be fully charged
- Vehicle power supply damaged (e.g. in back-up mode)