31
6.1.9 CD+G
This setting activates the copy capability of CD+G format. It
cannot be copied if the writers don’t support this format.
Default setting is “No”.
Press MODE switch to change and GO to exit.
6.1.10 CopyComp Eject
This setting controls the ejection of writers’ trays under “copy
+ compare” function. If the setting is “Yes”, the trays will eject
the passed discs after copying and it will re-insert the same
discs again for subsequent comparison. If setting is “No”, the
trays will not be ejected between copy and compare. The
default setting is “Auto” which means ejection of trays will
depend on the writers. If it supports auto-ejection, the tray
will be ejected after copying. If not, the tray will not be
ejected even when setting is “Yes”.
Press MODE switch to change and GO to exit.
6.1.11 Read CDDA index0
The setting controls the copying of data existed in index0.
Set to “Yes” will copy the data and set to “No” will make it
empty. Press MODE switch to change and GO to exit.
6.1.12 Skip Read Error
This setting controls error skipping during source reading.
The default setting is “No”. When an error is detected during
loading, the duplicator will stop to load and display read
To Next Page
Loading...