47
DVD-ROM
[*] ATA1.0 1.22 [Q]
It means the first slot (IDE#1) on controller board is
connected with DVD-ROM that is set to master mode (0)
and its firmware version is 1.22.
ATAPI DVD+RW 4X4X
[*] ATA7.1 B1HY [Q]
It means the 7
th
slot (IDE#7) on the controller board is
connected with ATAPI device DVD+RW writer that is set to
slave mode (1) and its firmware version is B1HY. The first
digit after ATA is slot number and the digit behinds the dot
is master and slave mode, 0 for master and 1 for slave.
6.7 Burn in
This function is a burn-in test function. It will run the emulate
write function continuously. Between each cycle of emulate
write, the blank discs in writers will be ejected automatically
and re-insert again for continuous testing. There is no real
writing on the blank discs and the discs will remain blank as
original after test. (DVD+R disc is not available under this
function)
To Next Page
Loading...