How to Change the Setting
1
2
3
4
5
6
1
This is a part to set
resolution. Default:
VGA
*Resolution
QVGA
(320X240)
VGA
(640x480)
MEGA
(1280X960)
Low High
2
Recording quality is set.
Default : Standard
(Rough, Low, Standard,
High, Fine)
3
Recording Speed (Recorded frames per
second) is set. Default: 5 (1~8)
4
Threshold of Impact Sensor is set.
Default : 0.6G(0.1~1.5G)
If the threshold value is too high, the
sensor is too dull to sense an occur-
rence of an event, when the threshold
is too low, it becomes too sensitive so
it will detect even slight shocks that
do not need to be detected. Thus,
an appropriate value should be set in
consideration of a user’s vehicle and
the condition of road while driving.
X-axis : Front-Back movement
Y-axis : Left-Right movement
Z-axis : Up-Down movement
* Note
As resolution, recording quality, and recording speed is set higher,
it takes more of the SD memory card storage.
UbONE
X-Driven
11
7
5
The recording time interval between
pre-event and post-event is set to the
unit of seconds.
Default – Pre-accident : 10 (0~10)
Post-accident : 10 (5~30)
6
Audio recording function is set.
Default: On
8
Set the time (zone) (in which the
device) is used.
8
7
Alarm function is set. (Default : On)
To Next Page
Loading...
Need help?
General