X-pole Xpert - Pole Maintenance, Removal, and Cleaning; Routine Checks and Takedown Procedure; Recommended Cleaning Products and Methods

To Next Page

To Previous Page

LEADERS IN POLE & AERIAL FITNESS

Anti/Counter-Clockwise

Tighten/Expand

Clockwise

Loosen/Shorten

3x Hex Screws

Pole maintenance & removal

Fig. (10.1)

Fig. (10.2)

Hex Key

ANTI/COUNTER - CLOCKWISE to

LOOSEN

A Pole B Pole

Lay the pole tubes on the ﬂoor and undo the X-Joints to disassemble the XPERT Pro. To undo the X-Joint – turn both

Hex Screws Anti/Counter Clockwise – undo screws until there is pressure against the key.

Fig. (10.3)

CAUTION: Store your Xpert pole only in a warm, dry place

Because the XPERT pole uses pressure to remain in

position. The pole tightness and X-Joints should be

checked regularly during use, ideally every

30 minutes.

If there is any movement, DO NOT USE, until

you have re-tightened. Always check the

X-Joints at the same time.

To take down the pole, ensure the X-Lock is in static/

non-spinning mode and undo the 3 x Hex Adjuster

Locking Screws (DO NOT completely remove the

screws). Then turn the pole clockwise to contract/

release the pole. Once the pole has been removed

from its position, the Upper Dome can be removed.

Cleaning your pole

Fig. (11.1)

X-Clean & Micro-Fibre Cloths

X-POLE strongly recommends the use of X-CLEAN with our

specially designed Micro-Fibre Cloths to clean and maintain the

surface of your XPERT Pro Pole. You can purchase these items from

our website www.xpole.com (ﬁrst select region, then search

for X-CLEAN) or your point of purchase.

DO NOT USE X-Clean on Brass, Powder Coated or Silicone Poles.

LOOSEN