To Next Page

To Previous Page

TECHNICAL SPECIFICATIONS

XP600.4 XP700.5 XP800.1

Output Power Rating

4 Ohm Load at 13.8V 100Wx4CH 50Wx4CH+200Wx1CH 500Wx1CH

2 Ohm Load at 13.8V 190Wx4CH 90Wx4CH+400Wx1CH 900Wx1CH

1 Ohm Load at 13.8V 190Wx4CH 90Wx4CH+400Wx1CH 900Wx1CH

Mono Bridge at 4 Ohm 380Wx2CH 180Wx2CH+400Wx1CH 150Wx2CH

Output Power Circuit Configuration Class AB Class AB + D Class D

Miscellaneous Spec

Input Selector S/W 2/4 2/4/6 No

Frequency Response-3dB 10 - 30KHz 10 - 30KHz 10 - 200Hz

Damping Factor 4Ω 200 200 200

S/N Ratio(A-weight) 95dB 95dB 66dB

THD 0,03% 0,03% 0,10%

Channel Separation 70dB 70dB 70dB

Input Gain Control 0.2V - 9.0V 0.2V - 9.0V 0.2V - 9.0V

Input Impedance 47k 47kΩ 47kΩ

Fan Yes Yes Yes

LED Power/Protect

Power/Protect/Overload

Protection( DC, Short, Thermal, Overload) Yes Yes Yes

Crossovers / Phase Shift

Phase Shift (0 - 180) No Yes, But only 5CH Yes

Crossover S/W for 1+2 channel HP/FULL/LP HP/FULL No

Variable Hi-Pass 40Hz - 200Hz 40Hz - 400Hz No

Variable Low-Pass 35Hz - 200Hz No 35Hz - 200Hz

Subsonic Filter 10Hz - 50Hz No 10Hz - 50Hz

Crossover S/W for 3+4 channel HP/FULL/LP HP/FULL/BAND No

Variable Hi-Pass 40Hz - 200Hz 40Hz - 200Hz No

Variable Low-Pass 35Hz - 200Hz 35Hz - 200Hz No

Subsonic Filter 10Hz - 50Hz No No

Crossover S/W for 5 channel No No No

Variable Hi-Pass No No No

Variable Low-Pass No 35Hz -200Hz No

Subsonic Filter No 10Hz - 50Hz No

Phone Jack for Remote Control No Yes Yes

Fuse Type 2 x 40 A ATC 2 x 30 A ATC 2 x 40 A ATC

Ne2 XP6004/7005/8001 RZ (D+UK) 16.08.2000 6:33 PM Seite 39

X-Pulse XP600.4 User Manual

Questions and Answers: