x-sense SC03 User Manual

Technical Specifications
Product Overview
J CAUTION!
Power supply
10-year sealed lithium battery
Sensor type
Smoke: Photoelectric
CO: Electrochemical
Product life About 10 years
Safety standards
Conforms with UL 217 & UL 2034 standards
Smoke sensitivity
0.97-1.79%/ft OBS
CO sensitivity
70 ppm: 60-240 minutes
150 ppm: 10-50 minutes
400 ppm: 4-15 minutes
Standby current < 6 UA (avg.)
Alarm current < 60 mA (avg.)
Best Operating ambient temperature 40-100 °F (4.4-37.8 °C)
Operating relative humidity < 85% RH (non-condensing)
Alarm loudness > 85 cB at 9.84 ft (3 m) @ 3.2 + 0.3 kHz pulsing alarm
Silence duration
Smoke: < 9 minutes;
CO: < 6 minutes
°06e
THIS SMOKE AND CO ALARM IS DESIGNED FOR INDOOR USE ONLY. DO NOT EXPOSE TO
RAIN OR MOISTURE. DO NOT KNOCK OR DROP THE ALARM. DO NOT OPEN OR TAMPER
WITH THE ALARM AS THIS COULD CAUSE MALFUNCTION.
Test & Silence Button
The Test & Silence button is used to test the unit's electronics and to silence the
unit during an alarm. When testing the alarm weekly, press the test button until
you hear a short beep, indicating that the alarm has entered the test mode.
Note: After a test has begun, the alarm will sound and the red LED will flash. This
does not indicate that smoke/CO is present.
If you press the test button during an alarm state, the unit will enter the silence
mode.
CO silence mode: press the test button during an alarm state, the unit will enter
the silence mode. If the CO density still exceeds the alarm threshold within 6
minutes, the unit will enter another alarm state. Otherwise, the unit will exit
from silence mode after 9 minutes.
Note: If the smoke or CO concentration has reached an alarm level, silence mode
cannot be enabled. This unit will continue to alarm until the smoke or CO
concentration has decreased to a low level.
°O07e

x-sense SC03 Specifications

General

Brand	x-sense
Model	SC03
Category	Smoke Alarm
Language	English