99
99
9
88
88
8
1.1.
1.1.
1. Set the House Code
to ‘A’ and the Unit
Code to ‘2.’
2.2.
2.2.
2. Plug a lamp into
the Lamp Module.
3.3.
3.3.
3. Plug the Lamp
Module into a
convenient AC
outlet.
X10 PX10 P
X10 PX10 P
X10 P
LALA
LALA
LA
TINUMTINUM
TINUMTINUM
TINUM
R R
R R
R
EMOTEEMOTE
EMOTEEMOTE
EMOTE
The X10 Platinum Remote lets you control
practically everything electrical in your
home. It has IR technology that lets you
control your TV, VCR, Cable and CD or
DVD player, and X10 RF technology that
lets you control lamps and appliances
anywhere in your home.
To find out more about configuring the
X10 Platinum Remote to work with your
audio/video equipment, see the section
titled “Setting Up your Remote.”
1.1.
1.1.
1. Push the tab and lift
off the battery
cover.
2.2.
2.2.
2. Insert four AAA
batteries, taking
care to match the +
and - marks in the
battery
compartment.
I I
I I
I
NSTNST
NSTNST
NST
ALLINGALLING
ALLINGALLING
ALLING
THETHE
THETHE
THE
CC
CC
C
OMPONENTSOMPONENTS
OMPONENTSOMPONENTS
OMPONENTS
TT
TT
T
RANSCEIVERRANSCEIVER
RANSCEIVERRANSCEIVER
RANSCEIVER
M M
M M
M
ODULEODULE
ODULEODULE
ODULE
The Transceiver Module (sold separately)
receives radio frequency (RF) commands
from the X10 Platinum Remote to operate
a lamp or appliance plugged into it. The
Transceiver Module also passes on
commands over your house wiring to
control other X10 modules (also sold
separately). Note that unlike the Lamp
Module you cannot dim and brighten a
lamp connected to the Transceiver
Module.
You should locate the Transceiver Module
centrally in the home for maximum range
when controlled by the Platinum Remote.
2.2.
2.2.
2. Plug a lamp or
appliance into the
Transceiver
Module.
3.3.
3.3.
3. Plug the Transceiver
Module into a
convenient AC
outlet. Fully extend
the antenna.
LL
LL
L
AMPAMP
AMPAMP
AMP
M M
M M
M
ODULEODULE
ODULEODULE
ODULE
The Lamp Module (sold separately) may
be used to control any incandescent
lamp rated up to 300W. It is not suitable
for other types of lamp such as
fluorescent or energy saving lamps, or
lamps which include a dimmer control.
Caution: Do not connect an appliance
such as a coffee pot or heater to the Lamp
Module. It may damage the module and
the appliance and could cause a fire
hazard.
1.1.
1.1.
1. Set the House Code
to ‘A.’