10 11
Operation
1. ON / OFF
a.After connecting the power supply, the unit will sound “DI” with LED flashes, then power LED
turns red, which means the unit is powering on and in standby mode.
b. Under standby mode, touch and hold ,until it sounds “DI”, then power LED turns off, which
means the unit is under off mode.
Under off mode, touch to directly enter into standby mode.
Note: No sound when you have setup the mute mode.
2.Call Remind
a.When the door station calls in, room station screen will display its image automatically.
b.When the room station is talking with door station, and another door station calls, the screen will
display Icon and no ringing.
3.Talk / Stop
3.1 Call Transfer To Talk
When the door station rings, touch to start talk.
3.2 When the room station is in monitor mode, touch to start talk.
Note: Refer to operation 4.1 for Monitor operation.
Operation
3.3 Standby Transfer To Talk
Under standby mode, touch to start talk with Door 1.
If only door 2 connected with, touch to start talk with door 2 directly.
3.4 Transfer Call
When the room station is talking with the door station, touch and hold to choose room number
you need to transfer the call, then touch to transfer call. Now the second room station sounds the
ring, touch to start talk. Other room stations enter into busy mode.
3.5 Hang up
Under talk mode, touch to exit talk. Or you can wait 90secs , it will automatically exit.
4.Monitor
4.1 Monitor Door Station
nd
Under standby mode, touch to switch monitoring between door1/door2/exit. If no 2 door is
connected, it will exit directly.
To Next Page
Loading...
Need help?
General