Need help?Do you have a question about the Xantrex XHR 300-3.5 and is the answer not in the manual?
General| Brand | Xantrex |
|---|---|
| Model | XHR 300-3.5 |
| Category | Power Supply |
| Language | English |
Details the scope and length of the product warranty.
Describes Xantrex's responsibilities for repair or replacement.
Provides contact information for warranty service.
Lists conditions and damages not covered by the warranty.
States limitations of warranties and Xantrex's liability.
Introduces the purpose and content of the operating manual.
Identifies intended users and outlines manual sections.
Explains safety symbols and their meanings.
Overview of the power supply's capabilities and features.
Details the functions of front panel buttons, knobs, and displays.
Identifies rear panel connections and programming switches.
Explains the configuration options for the SW1 DIP switch.
Describes the terminals and functions of the J2 connector.
Lists detailed electrical performance parameters.
Covers input power requirements and operating conditions.
Details physical construction, dimensions, and weight.
Outlines the essential steps for setting up the power supply.
Instructions for initial checks, cleaning, and packaging.
Procedures for returning products for warranty or repair.
Guidance on installing and ensuring adequate airflow.
Details on connecting the unit to AC power.
Procedures for verifying power supply operation.
Recommendations for connecting loads and wiring.
Instructions for setting up local and remote sensing.
Explains constant voltage/current modes and automatic crossover.
Details factory settings and how to set output voltage/current.
Guidance on operating multiple units together.
Methods for connecting units in series or parallel.
How to configure for positive-positive or positive-negative outputs.
How to set up and use the OVP feature.
Using the front panel or remote shutdown function.
Details the OTP feature and recovery settings.
Steps for diagnosing and resolving operational issues.
Controlling output via external analog sources.
Step-by-step guide for analog programming.
Using J2 connector for output monitoring.
Details the optional ISOL interface for isolated control.
How to connect and use the ISOL interface.
Environment, safety, and required equipment for calibration.
Calibrating front panel voltage and current meters.
Specific steps for calibrating voltage and current meters.
Calibrating the OVP setpoint and trip level.
Adjusting voltage and current programming circuits.
Calibrating output voltage and current monitor circuits.
To Next Page