EasyManua.ls Logo

Xceed 7LI18VK - When to Charge the Battery

Default Icon
39 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
and Vehicles where the inside temperature can climb
to dangerous levels in the direct sunlight and on high
temperature days. THINK BEFORE LEAVING YOUR
LITHIUM ION BATTERY PACK IN STORAGE.
• The battery can be charged or operated at temperatures
between C and 40° C.
NEVER CHARGE YOU LITHIUM ION BATTERY BELOW
OR ABOVE TEMPERATURES RECOMMENDED
OTHERWISE FIRE OR SERIOUS DAMAGE TO THE
BATTERY PACK MAY OCCUR.
The most suitable temperatures to charge the battery pack
are between 20 - 25° C.
• Always allow the battery pack to cool down after
charging, do not place it in a hot environment such as a
metal shed or open trailer left in the sun.
• Take care where the tool is stored. Do not store in areas
of corrosive fumes, or salt air or similar conditions. Try
and store the tool in the packaging supplied with the tool.
• Do not dispose of the battery in a fire or put the battery
into a microwave oven, conventional oven, dryer, or high-
pressure container. Under these conditions, the battery
may explode.
• Never attempt to open the battery pack, puncture the
battery or subject the battery to strong physical shock.
• If the plastic housing of the battery pack breaks open
or cracks, immediately discontinue its use and do not
recharge it. Ensure the battery pack clip is in good
condition and will not allow the pack to fall free from the
tool. If the clip is damaged or for any reason is not locking
the pack in place Do Not continue to use.
• Stop using the battery if it exhibits abnormal heat, odour,
colour, deformation, or is in an abnormal condition.
• If you detect leakage or a foul odour, it is especially
important to keep the battery away from fire. If battery
liquid leaks onto your skin or clothes, wash well with
clean water immediately. If liquid leaking from the
battery gets into your eyes, do not rub your eyes.
Rinse your eyes well (for at least 10 minutes) with clean
water, and consult a doctor immediately. Do not use a
leaking battery.
• Handle batteries with care to avoid shorting the battery
with conducting materials, such as nails, screws, metal
watch bands, rings, bracelets, and keys. The battery may
overheat and could burn you.
• After the battery has reached the end of its useful life,
we recommend recycling the materials at your local
municipal council recycling centre. DO NOT attempt to
replace the battery cells in the battery pack, repair or
modify any part of the battery pack assembly
• When recycling, make it nonconductive by applying
insulating tape to the terminals located on the battery.
When to charge the battery
New batteries are shipped in a low charged condition and
should be fully charged before use.
The battery pack can be recharged at any time during use,
provided the pack is not overheated.
If the battery pack starts to cut out due to low voltage, or
previous tasks undertaken can no longer be performed, it is
suggested to stop using the tool and recharge the battery.
For storage, it is suggested to recharge the battery between
50% and 75% charge using the 1 hour plug pack charger,
after the battery pack has been used and charged a few
times.
Contents
- 1 x 18V Drill driver (bare tool)
- 1 x 18V Trim Saw (bare tool)
- 1 x 18V Reciprocating Saw (bare tool)
- 1 x 18V Rotary Tool (bare tool)
- 1 x 18V LED Torch (bare tool)
- 1 x 18V Oscillating Tool (bare tool)
- 1 x 18V Vacuum Cleaner (bare tool)
- 2 x 18V Lithium-Ion Batteries - 1 x 18V 1 Hour Charger
- 1 x Hex Key - 1 x Rotary Tool Spanner
- 1 x Trim Saw Parallel Fence - 1 x Tool Bag
- 2 x Vacuum Dust Bags (Cloth & Paper)