Portable LED HeadLight System (L2S15) www.xenosys.co.kr
① Charging Signal LED: Orange – Charging, Green – Finished charging.
② DC5V Connecting Jack: DC5V power supply connecting jack.
③ Charging terminals: Assemble the battery pack (BTP15) and connect power supply
to start charging the battery.
WARNING:
- Do not connect any metallic objects to the charging terminal except the battery.
- Charging terminal is weak at external shock, so be careful on assembling the battery pack. If
the charging terminal is broken, it is out of order.
Warning – Do not use non-Xenosys supplied power supply. This will cause severe damage
to the cradle & main body which is also excluded from the under warranty.
6. Power Supply
① Charging plug: To supply the power to DC5V connecting jack.
Warning – Do not use any other device randomly which may cause the defective reason.
In case of using non-Xenosys-supplied charger with higher voltage (over 5V), it will cause the
severe damage to main body. Please check if its Xenosys supplied charger and the serial
number. If it’s Xenosys supplied one, then stop using and contact the distributor (dealer) or
the manufacturer. If not, make sure to use Xenosys DC5V power supply.
To Next Page
Loading...
