Portable LED HeadLight System (L2S15) www.xenosys.co.kr
OPERATING INSTRUCTION
A. Preparation before usage
1. Check components
Components are shown on page 8~9. They can differ from the picture and replace or
delete with new parts for better performance.
2. Charging battery & Assembling components
The battery is not completely charged, so charge them fully before the first-time usage.
① Connect power supply & charger to supply the power.
② If the battery is fully charged, it will show green light on charger LED.
③ Assemble the control unit & fully charged battery, then connect LED lens module wire
to the circular connector of the control unit.
B. Operating Instructions
1. Finish the preparation and put the main body to waist belt or inside of pocket.
2. When using headband, connect LED lens module to headband attachment and adjust to
your head. When using surgical telescope, connect LED lens module to glasses nose
bridge part.
3. Use gown clips to fix the wire and remove the protection cap of LED lens module.
4. Turn on the button of control unit to start the light operating and change the position of
lens module to your own needs
5. Press the intensity change button either control unit or remote controller to match your own
needs of light intensity.
WARNING – On turn-on LED, do not look directly into LED lens module or some one’s
eyes to avoid the risk of permanent eye damage.
C. Maintenance & Storage after use
1. If the usage is done, press the power ON/OFF button to turn off. Then store it to the case
after cleaning dirt or bloods for further use.
Caution – When no-use for long time, make sure to remove the battery from the battery pack.
To Next Page
Loading...