Xerox 8264E - Safety Instructions

Xerox 8264E User Maintenance and Cleaning Guide 5
 If blurring or incomplete printing continues after one head cleaning, repeat
the process, using the Strong cleaning setting.
 If blurring or incomplete printing do not disappear after several head
cleanings, refer to Troubleshooting in the User Guide, and take appropriate
measures.
Cleaning the Cleaning Wiper
This section describes when and how to clean the cleaning wiper.
1. Cleaning frequency
The cleaning wiper should be cleaned once or twice a week or when blurs or in
complete printing appear on printed media after head cleaning.
2. Cleaning method
Follow the procedure below to clean the cleaning wiper.
Note:
 Use a new foam swab or lint free cloth to clean the cleaning wiper. Use Eco-
cleaning solution or Isopropyl Alcohol with the swab or cloth.
For details on the foam swab and the lint free cloth, refer to Options/Supply List in the
User Guide.
1. With the printer turned ON, make sure of the following.
 Printing or other operations are not in progress.
 "Ready to Print" displays in the control panel.
2. Display the CR Maintenance menu in the control panel.
a. Press the [Menu] key. "Menu 1: Setup>" displays in the control panel.
b. Press the [>] key. "Set1: MediaType" displays in the control panel.