Electrical Safety
GENERAL GUIDELINES
WWaarrnniinngg::
• Do not push objects into slots or openings on the printer. Touching a voltage point or shorting out a
part could result in fire or electric shock.
• Do not remove the covers or guards that are fastened with screws unless you are installing optional
equipment and are instructed to do so. Power off the printer when performing these installations.
Disconnect the power cord when removing covers and guards for installing optional equipment. Except
for user-installable options, there are no parts that you can maintain or service behind these covers.
The following are hazards to your safety:
• The power cord is damaged or frayed.
• Liquid is spilled into the printer.
• The printer is exposed to water.
• The printer emits smoke, or the surface is unusually hot.
• The printer emits unusual noise or odors.
• The printer causes a circuit breaker, fuse, or other safety device to activate.
If any of these conditions occur, do the following:
1. Power off the printer immediately.
2. Disconnect the power cord from the electrical outlet.
3. Call an authorized service representative.
POWER CORD SAFETY INFORMATION
Before operating your printer, read the following instructions carefully. For details, contact your Xerox representative.
WWaarrnniinngg::
• The electrical supply for the device must meet the requirements stated on the data plate on the rear
of the device. If you are not sure that your electrical supply meets the requirements, consult your local
electricity provider or a licensed electrician.
• Do not use an extension cord.
• Do not remove or modify the power cord.
Refer to these instructions to ensure the continued and safe operation of your printer.
Xerox
®
AltaLink
®
B8145/B8155/B8170 Multifunction Printers Safety, Regulatory, Recycling, and Disposal Reference
Guide
7
Safety
To Next Page
Loading...
Need help?
General
