• Use the power cord that is supplied with your printer.
• Plug the power cord directly into a properly grounded electrical outlet. Ensure that each end of the cord is
connected securely. If you do not know if an outlet is grounded, ask an electrician to verify that the outlet is
grounded.
• Do not use a ground adapter plug to connect the printer to an electrical outlet that does not have a ground
connection terminal.
WWaarrnniinngg:: To avoid the potential of an electrical shock, ensure that the printer is grounded properly.
Electrical products can be hazardous if misused.
• Verify that the printer is plugged into an outlet that provides the correct voltage and power. Review the
electrical specification of the printer with an electrician, if necessary.
• Do not place the printer in an area where people can step on the power cord.
• Do not place objects on the power cord.
• If the power cord becomes frayed or worn, replace the power cord.
• Do not unplug or plug in the power cord while the printer is powered on.
• To avoid an electrical shock and damage to the cord, grasp the plug when you unplug the power cord.
• The electrical outlet must be near the printer and must be easily accessible.
The power cord is attached to the printer as a plug-in device on the back cover of the printer. If it is necessary to
disconnect all electrical power from the printer, disconnect the power cord from the electrical outlet. For details, refer
to the User Guide.
BATTERY SAFETY INFORMATION
• The Printed Wire Board Assembly Electronic Switching System (PWBA ESS) in this printer uses a lithium battery.
• Do not attempt to repair or replace the lithium battery. If there is a problem with the battery, contact an
authorized service representative to correct the problem.
WWaarrnniinngg::
• If the battery for the PWBA ESS is installed incorrectly, there is a risk of explosion.
• The lithium battery in this printer contains Perchlorate Material. For information about the special
handling procedures associated with Perchlorate Material, refer to www.dtsc.ca.gov/hazardouswaste/
perchlorate.
EMERGENCY POWER OFF
If any of the following conditions occur, power off the printer immediately and disconnect the power cord from the
electrical outlet. Contact an authorized Xerox service representative to correct the problem if:
• The equipment emits unusual odors or makes unusual noises.
• The power cable is damaged or frayed.
• A wall panel circuit breaker, fuse, or other safety device has been tripped.
8
Xerox
®
AltaLink
®
B8145/B8155/B8170 Multifunction Printers Safety, Regulatory, Recycling, and Disposal Reference
Guide
Safety
To Next Page
Loading...
Need help?
General
