Xerox C235 - Page 284

תונקת
278 Xerox
®
C235 תינועבצ תבלושמ תספדמ
ךירדמשמתשמל
Mode
Description
Power consumption (Watts)
Printing
The product is generating hard-copy output from
electronic inputs.
One-sided: 385
Two-sided: 260
Copy
The product is generating hard-copy output from hard-
copy original documents.
385
Scan
The product is scanning hard-copy documents.
22 (without fax), 24 (with fax)
Ready
The product is waiting for a print job.
17
Sleep Mode
The product is in a high-level energy-saving mode.
1.1
Hibernate
The product is in a low-level energy-saving mode.
N/A
Off
The product is plugged into an electrical outlet, but the
power switch is turned off.
0.1
The power consumption levels listed in the previous table represent time-averaged measurements.
Instantaneous power draws may be substantially higher than the average.
Sleep Mode
This product is designed with an energy-saving mode called Sleep Mode. The Sleep Mode saves
energy by lowering power consumption during extended periods of inactivity. The Sleep Mode is
automatically engaged after this product is not used for a specified period of time, called the Sleep
Mode Timeout.
Note: Factory default Sleep Mode Timeout for this product is 15 minutes.
By using the configuration menus, the Sleep Mode Timeout can be modified between 1 minute and 120
minutes. If the print speed is less than or equal to 30 pages per minute, then you can set the timeout only
up to 60 minutes. Setting the Sleep Mode Timeout to a low value reduces energy consumption, but may
increase the response time of the product. Setting the Sleep Mode Timeout to a high value maintains a
fast response, but uses more energy.
Hibernate Mode
This product is designed with an ultra-low power operating mode called Hibernate mode. When
operating in Hibernate Mode, all other systems and devices are powered down safely.
The Hibernate mode can be entered in any of the following methods:
• Using the Hibernate Timeout
• Using the Schedule Power modes
Note: Factory default Hibernate Timeout for this product in all countries or regions is 3 days.
The amount of time the printer waits after a job is printed before it enters Hibernate mode can be
modified between one hour and one month.