Page 11
Printer driver Configuring the Windows printer drivers
To use the printer driver on Windows 2000/XP/Server 2003, you must first configure the
print and spool options on the Advanced tab of the printer driver after installation is
complete.
TO CONFIGURE THE OPTIONS ON THE ADVANCED TAB
1 Windows 2000: Click Start, choose Settings, and then choose Printers.
Windows XP: Click Start and choose Printer and Faxes.
Windows Server 2003: Click Start, choose Control Panel, and then choose Printers and Faxes.
2 Click the Fiery Color Server icon and choose Properties from the File menu.
3 Click the Advanced tab.
4 Select the following options:
• Spool print documents
• Start printing immediately
• Print spooled documents first
5 Clear the following option:
• Enable advanced printing features.
6 Click Apply to save your changes and click OK.
Job Monitor
When you install a Windows printer driver, Job Monitor is automatically installed.
Incorrect information in Windows PostScript driver
In the Windows PostScript driver Properties window of the printer driver (Properties >
General) the Features area incorrectly lists No next to Double-sided. However, double-sided
(duplex) printing is supported.
Choosing PPD for Mac OS X printer driver
When you configure the Mac OS X printer driver (using the Printer Setup Utility), we
recommend that you select the printer model (XXXX PS) from those listed under Xerox.
If you select the model using Other, be sure you browse to the
<Startup disk>:Library:
Printers:PPDs:Contents:Resources
:<language>.proj folder to select the PPD and not to the
folder that contains the installer.
To Next Page
Loading...
Need help?
General
